unwrap this layer and make sure that it stays away from the exposed wires you need to work on (use tape if you need to). Click to list> The micro-USB connector is often used for portable devices charging (with micro-usb charging cable ) or mobile devices data transfer (with micro-usb data cable ). now there should be another layer of foil like material wrapped around the wires that you need to get to. Micro-USB is a standard connector for a wide range of portable devices, including cell phones and smartphones The pinout should fit 74 devices/models. now pull the braided layer of shielding back and down the cable foe each cable. now take your razor blad and cut down the center of both usb cables making sure not to cut the outer layer of braided shielding on each of them. leave several inches on the end that you cut off so that you can reuse the end if needed for another project. Again, I covered everything in epoxy to protect them from fatigue.Next grab a pair of wire cutters ( I used my mini tool to do this) and cut an end of both of your usb cables off. I found it makes it easier to line everything up for the epoxy application if you wrap the wire strands with electrical tape and tape the 2 ends together. Make sure you use heat shrink tubing to cover the bare connections, you don't want the leads to short out after you cover it all in epoxy. The metal inside the plug was longer than I expected, so the adapter didn't turn out as small as I had hoped, but it works for what I need it for. Once there is a slice the plastic peels back very easily. I ran a utility knife down the molded plastic around the USB ends to remove it. Step2: After the identification of the type of USB connector used on both ends, note down the pinout diagram of that particular USB type. I cut the cable ends off, leaving enough spare wire to be able to make the connections. Step1: First of all find out the type of USB connector used in the cable.

I decided to make a flip adapter out of a USB extension wire. These ports on my computer and laptop are upside down, so I can't see my activity light. It shouldn't make a difference, but when I use my thumb drive, its handy to be able to see the activity light. I have a few ports on my computers that are upside down.

Free download mini usb pinout